Duro-Last 2-Piece Flex Snap-On Compression System - Manual

DATA SHEET
2-Piece Flex Snap-On Compression
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The 2-Piece Flex Snap-On Compression system is
made with a flat face to help it conform to a radius edge.
The system consists of a 24-gauge Galvalume® base
and a snap-on cover
notched in 3” intervals to easily
snap over radial surfaces.
This edge is fabricated in 10’ lengths; 3” – 8”
widths.
Cover is double-hemmed to prevent roof
material from chaffing.
Can be installed on both inside and outside
radius edges.
Standard 2-Piece Snap-On Compression can be
ordered with a flat face to match this detail.
This edge trim does not conform to an arched or
vaulted radius.
Contact Duro-Last
®
or EXCEPTIONAL
®
Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED ® and ENERGY STAR ® compliant; Recyclable.
Installation:
1. A wood nailer is required if 1” or greater of
insulation is used.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawings #3110 and #3513.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Warranty:
Duro-Last® offers a wide range of warranty coverage
for EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and a color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .040 Mill or Kynar ®
Stainless Steel 24-gauge N/A
Bonderized Steel 24-gauge N/A
Galvalume 24-gauge Mill or Kynar ®
Copper 16 oz. Mill