Duro-Last T-Edge - Manual

DATA SHEET
T-Edge
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The T-Edge provides a smooth edge finish and easy deck
termination. The system consists of three separate
components: a drip edge base, hook strip, and splice plate
that are hooked together to form an aesthetically-pleasing
edge.
Fabricated in 10’ lengths; 2” – 8” widths.
Can be modified to accommodate various pitches
and bend up to a 6/12 slope.
Top piece consists of a vinyl-coated hook strip with
a 6” attached membrane skirt. Bottom drip edge
piece available in any metal finish.
Does not require an overlapping allowance.
Ready to assemble inside and outside corners are
available.
Contact Duro-Last
®
or EXCEPTIONAL
®
Metals to request
a color chart, samples and information regarding custom
metals and finishes.
Energy Efficiency:
LEED
®
and ENERGY STAR
®
compliant; Recyclable.
Installation:
1. Attach to a wood nailer.
2.
This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3.
Install in accordance with Duro-Last detail drawing
#3550.
4.
Any deviation from the requirements set forth in the
detail drawings must be pre-approved, in writing, by
the EXCEPTIONAL Metals Technical Department.
Codes and Standards:
ANSI/SPRI ES-1 Compliant for 3” – 8” in 24-
gauge galvanized and .040 aluminum.
Meets TAS 111-95 test for 4”.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your local
representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .040 Mill or Kynar
®
Stainless Steel 24-gauge N/A
Bonderized Steel 24-gauge N/A
Galvalume 24-gauge Mill or Kynar ®