Duro-Last 2-Piece Snap-On Compression LG System - Manual

DATA SHEET
2-Piece Snap-On Compression LG
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Description:
The 2-Piece Snap-On Compression LG (Large Face)
system may be used as a perimeter flashing for the
Duro-Last
® roofing system. The system consists of a
22-gauge Galvalume ® base and a snap-on aluminum
cover.
Base and cover is fabricated in 10’ lengths and
9 ” – 13” widths.
Cover is double-hemmed to prevent roof
material from excessive wear.
Bird beak strengthening bend on base.
Pre-punched holes in base.
Ready to assemble inside and outside corners
are available.
Contact Duro-Last or EXCEPTIONAL ® Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED ® and ENERGY STAR ® compliant; Recyclable.
Installation:
1. A wood nailer is required if 1” or greater of
insulation is used.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawing #3115.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Codes and Standards:
ANSI/SPRI ES-1 compliant.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Material Gauge Finish
Aluminum .040 Mill or Kynar
®