Duro-Last Termination Bar - Manual

Duro-Last: The Proven Performer®
"Duro-Last" and "The World's Best Roof" are registered marks owned by Duro-Last , Inc.
www.duro-last.com 800-248-0280
DATA SHEET
2009
30
DURO-LAST ® TERMINATION BAR
Description:
Duro-Last® Termination Bar (available in white, gray
and tan colors) is fabricated from a rigid exterior vinyl
with slotted holes 6 inch (152 mm) on center.
Duro-Last termination bar may be used as perimeter
detail for the Duro-Last roofing system and as
termination on any square or rectangular penetration.
Because of its symmetrical design, it is reversible.
Duro-Last Termination Bar is available in 10 ft. (3 m)
lengths only. Duro-Last, Inc. will supply the
termination bar in multiples of 10 ft. (3 m) and has two
standard packages. The small tube package contains
a maximum of 170 ft. (52 m) while a large box
contains a maximum of 500 ft. (152 m).
Material Safety Data Sheet:
Product: 10 foot Extrusions
MSDS Number: 1225
Installation:
1. Duro-Last Termination Bar shall be fastened 6 inch
(152 mm) on center with approved fasteners.
2. All termination bar must be fastened 1 inch (25
mm), maximum, from each corner or end of the
bar.
3. The top edge of all sections of termination bar
must be caulked.
4. It is necessary to leave a ¼ inch (6.3 mm) space
between all sections of termination bar to account
for expansion and contraction.
5. All vertical applications require caulk on both sides.
6. Refer to details 3010 & 3020 for installation
information.