Rainbow Electronics GM862-QUAD-PY - Manual (Page 53)

GM862-QUAD / PY Software User Guide
1vv0300747 Rev. 3 - 10/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 53 of 96
3.4.1 Enabling/Disabling the power saving function
Send command
AT+CFUN=[[,]]
where:
Parameters:
- is the power saving function mode
0 - minimum functionality, NON-CYCLIC SLEEP mode: in this mode, the AT interface is not
accessible. Consequently, once you have set level 0, do not send further characters.
Otherwise these characters remain in the input buffer and may delay the output of an unsolicited
result code. The first wake-up event stops power saving and takes the ME back to full functionality
level =1.
1 - mobile full functionality with power saving disabled (factory default)
2 - disable TX
4 - disable either TX and RX
5 - mobile full functionality with power saving enabled
- reset flag
0 - do not reset the ME before setting it to functionality level
•
wait for response:
Response Reason Action
OK The power save is now active
ERROR some error occurred Enable extended result codes
(see par. 2.5.2.1), and retry.
+CME ERROR: 4 operation not supported Check command syntax and
value.
TIP: The power saving function is disabled by default when the device starts up, in order to
guarantee that even without the DTR line support it is possible to exchange commands with
the module; for this reason the power saving setting command shall be issued after every
power up.
NOTE: The DTR functionality is usable only when +CFUN=5 is selected.