Rainbow Electronics GM862-QUAD-PY - Manual (Page 21)

GM862-QUAD / PY Software User Guide
1vv0300747 Rev. 3 - 10/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 21 of 96
•
send command
AT#MONI?
•
wait for response in the format:
#MONI: BSIC: RxQual: LAC: Id: ARFCN:
PWR: dBmTA:
OK
or in the case the network name is not known:
#MONI: Cc: Nc: BSIC: RxQual: LAC: Id: ARFCN:
PWR: dBm TA:
OK
where:
= name of network operator
= country code
= network operator code
= progressive number of adjacent cell
= base station identification code
= quality of reception (0-7) (same as of +CSQ command)
= localization area code
= cell identifier
= assigned radio frequency channel
= received signal strength in dBm (same as "decoded" rssi value)
= timing advance
For example:
command:
AT#MONI=0
Answer:
OK
command:
AT#MONI?
Answer:
#MONI: I TIM BSIC:23 RxQual:7 LAC:AEAD Id:5265 ARFCN: 59 PWR: -80 dBm TA:0
OK
In this case the mobile is registered on the network "I TIM", the signal strength is -80dBm (MMI may
indicate 4 antenna bars as reported on the table 5). The other information received is strictly technical
and should not be given to the user.
For example2:
command:
AT#MONI=0