Rainbow Electronics RC2100 - Manual (Page 16)

RC2100
 2005 Radiocrafts AS RC2100 Data Sheet (rev. 1.0) Page 16 of 22
RF Frequency, Output Power Levels and Data Rates
The following table shows the available RF channels and their corresponding frequencies,
nominal output power levels and available data rates.
RF channel Output power Data rate
1-83:
f
RF
=2400+N MHz
where N is the channel number
Factory setting: 50: 2450 MHz
1: -25 dBm
2: -15 dBm
3: -10 dBm
4: -5 dBm
5: -0 dBm
250 kbit/s fixed
RF channel and output power level can be set using the configuration commands ‘C’ and ‘P’
respectively. The data rate cannot be changed. The default RF channel and output power
level can be set in the configuration memory by using the ‘M’ command setting
RF_CHANNEL and RF_POWER. The default values are used after power ON and RESET.
The default factory settings are shown in bold in the table above.
For more details on changing the RF channel, output power or data rate, refer to the RC232™
User Manual describing the configuration commands.
The use of RF frequencies and maximum allowed RF power is limited by national regulations.
The RC2100 is complying with the applicable directives within the European Union and
meeting FCC and ARIB standards for US/Canada and Japan. The module complies also with
most other regulations for license-free use world-wide.
External PA control
Pin 23 can be used to control an external Power Amplifier (PA), external Low Noise Amplifier
(LNA) and Transmit/Receive (T/R) switch. The control signal is active low logic level (0-VDD)
digital output. The PA_EN signal is active (low) while the internal PA is on. The PA is on
during transmitting mode.