beautypg.com

Rc2100 – Rainbow Electronics RC2100 User Manual

Page 14

background image

RC2100

2005 Radiocrafts AS

RC2100 Data Sheet (rev. 1.0)

Page 14 of 22

OFF

IDLE

t

OFF-IDLE

SLEEP

IDLE

t

SLEEP-IDLE

RESET

IDLE

t

RESET-IDLE

CONFIG

CONFIG

t

C-CONFIG

IDLE

t

CONFIG-IDLE

’C’

’X’

CONFIG

MEMORY CONFIG

CONFIG

t

MEMORY-CONFIG

’M’

0xFF

IDLE

t

CONFIG-IDLE

’X’

Symbol

Value

Description / Note

t

RX-TXD

600 us

Time from last byte is received from the air until first character is

sent on the UART

t

TXD

Min 621 us

t

TXD

= # bytes received x 621 us/char (10 bits at 19.2 kBd + 100 us

delay per character)

t

TXD-IDLE

1.5 ms

Time from last character is sent on the UART until module is in

IDLE mode (ready for RXD and RX)

t

PACKET-

TIMEOUT

Programmable

If enabled, the packet timeout can be configured from 16/32 ms to

4.08 s. If end character or fixed packet length is used, the timeout

is 0.

T

RXD-CTS

14-36 us

Time from last character is received by the UART (including any

timeout) until CTS is activated

t

RXD-TX

680 us (1 char)

2.16 ms (16 chars)

Time from last character is received by the UART (including any

timeout) until the module sends the first byte on the air. Depends

on the number of characters to be sent.

T

TX-IDLE

1.4 ms

Time from last character is sent on the air until module is in IDLE

mode (ready for RXD and RX)

t

OFF-IDLE

Typ 1.6 sec

Long start-up due to slow 32kHz oscillator

t

RESET-IDLE

Typ 28 ms

From RESET when 32 kHz oscillator is running

t

SLEEP-IDLE

4 ms

t

CONFIG->

2 ms

From CONFIG is asserted until prompt ‘>’ (including the prompt)

t

C-CONFIG

1.6 ms

After setting new channel until prompt ‘>’ (including the prompt)

t

CONFIG-M

1.0 ms

After sending the ‘M’ command until prompt ‘>’ (including the

prompt)

t

MEMORY-

CONFIG

26 ms

In this period the internal flash is programmed.

Do not reset, turn

the module off, or allow any power supply dips in this period as it

may cause permanent error in the Flash configuration memory.

After 0xFF the host should wait for the ‘>’ prompt before any

further action is done to ensure correct re-configuration.

t

CONFIG-IDLE

1.3 ms