Cobalt Digital COMPASS 9414 4 In _ 4 Out Fiber-to-BNC Receiver _ Crosspoint Card - Manual (Page 6)

1
9400-Series Card Firmware Versions and this Manual
1-2 9400-SERIES PRODUCT MANUAL 9400S-OM (V1.1)
This manual consists of the following chapters:
• Chapter 1, “Introduction” – Provides information about this
manual and what is covered. Also provides general information
regarding the 9400-series.
• Chapter 2, “Installation and Setup” – Provides instructions for
installing the 9400-series in a frame, and optionally installing a
9400-series Rear
I/O Module.
• Chapter 3, “Operating Instructions” – Provides overviews of
operating controls and instructions for using the 9400-series.
This chapter contains the following information:
• Manual Conventions (p. 1-3)
• Safety Summary (p. 1-5)
• 9400-series Functional Description (p. 1-6)
• Technical Specifications (p. 1-10)
• Warranty and Service Information (p. 1-12)
• Contact Cobalt Digital Inc. (p. 1-13)
9400-Series Card Firmware Versions and this Manual
When applicable, Cobalt Digital Inc. provides for continual product
enhancements through software updates. As such, functions described in this
manual may pertain specifically to cards loaded with a particular software
build.
The Software Version of your card can be checked by viewing the Card Info
menu in DashBoard™. You can then check our website for the latest software
version currently released for the card as described below.