Cobalt Digital COMPASS 9414 4 In _ 4 Out Fiber-to-BNC Receiver _ Crosspoint Card - Manual (Page 21)

9400S-OM (V1.1) 9400-SERIES PRODUCT MANUAL 2-3
Installation and Setup
Installing a Rear I/O Module
Installing a Rear I/O Module
9400-Series Rear I/O Modules
Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 9400-Series.
Table 2-1 9400-Series Rear I/O Modules
9400-Series Rear I/O Module Description
CLASS 1 LASER PRODUCT - IEC 60825-1:2007. Never look into fiber connector or cable end
of device transmitting an optical signal. The transmitted light is not visible and can cause
permanent eye damage. Do not perform connection/disconnection with sending or receiving
device powered.
Note: Rear I/O Modules should be ordered corresponding to the card model and format of fiber connection desired. All 9400-series
rear modules are standard-width (occupies 2 card slots) and are available only for 20-slot frames (e.g., 8321 frame). See below.
RM20-9404-B 20-Slot Frame Rear I/O Module (Standard Width) 4 BNC In, 4 Fiber Out
RM20-9403-B 20-Slot Frame Rear I/O Module (Standard Width) 4 BNC In, 3 Fiber Out
RM20-9402-B 20-Slot Frame Rear I/O Module (Standard Width) 4 BNC In, 2 Fiber Out
RM20-9401-B 20-Slot Frame Rear I/O Module (Standard Width) 4 BNC In, 1 Fiber Out
RM20-9414-B 20-Slot Frame Rear I/O Module (Standard Width) 4 Fiber In, 4 BNC Out
RM20-9413-B 20-Slot Frame Rear I/O Module (Standard Width) 3 Fiber In, 4 BNC Out
RM20-9412-B 20-Slot Frame Rear I/O Module (Standard Width) 2 Fiber In, 4 BNC Out
RM20-9411-B 20-Slot Frame Rear I/O Module (Standard Width) 1 Fiber In, 4 BNC Out
Note: Add fiber connector suffix to part numbers above to specify fiber connection type (-LC, -ST, -SC, -FC). (For example,
RM20-9404-B fitted with LC connectors is ordered as “RM20-9404-B-LC”.)
RM20-9401-B thru RM20-9404-B Provides the following connections for Tx cards 9401
thru 9404:
• Four BNC coaxial inputs (BNC IN 1 thru BNC IN 4)
• Up to four Fiber outputs (FIBER OUT 1 thru
FIBER OUT 4)