User control interface, User control interface -8, S. figure 1-2 s – Cobalt Digital COMPASS 9414 4 In _ 4 Out Fiber-to-BNC Receiver _ Crosspoint Card User Manual
Page 12: 9400-series functional description, Frames such as the cobalt
1
9400-series Functional Description
1-8
9400-SERIES PRODUCT MANUAL
9400S-OM (V1.1)
Figure 1-2 9411 thru 9414 Rx Card Functional Block Diagram
User Control Interface
The 9400-series uses DashBoard™ as the normal graphical user interface for
the card, similar to other Cobalt
®
COMPASS™ cards.
Using DashBoard™, the 9400-series and other cards installed in openGear
®
frames such as the Cobalt
®
8321-C Frame can be controlled from a computer
and monitor
1
. DashBoard™ allows users to view all frames on a network with
control and monitoring for all populated slots inside a frame. This simplifies
the setup and use of numerous modules in a large installation and offers the
ability to centralize monitoring. Cards define their controllable parameters to
DashBoard™, so the control interface is always up to date.
The DashBoard™ software can be downloaded from the Cobalt Digital Inc.
website:nter “DashBoard” in the search window).
The DashBoard™ user interface is described in Chapter 3,“Operating
Instructions”.
Optical/Elect
Converter
9411
Crosspoint
On/Off
Selectable
Reclock
On/Off
Selectable
Reclock
On/Off
Selectable
/Reclock
On/Off
Selectable
Reclock
Network Remote
Control
Ethernet 10/100 (on frame)
FIBER IN 1
FIBER IN 2
FIBER IN 3
FIBER IN 4
BNC OUT 4
BNC OUT 3
BNC OUT 2
BNC OUT 1
Optical/Elect
Converter
Optical/Elect
Converter
Optical/Elect
Converter
9412
9413
9414
1. openGear® is a registered trademark of Ross Video Limited. DashBoard™ is a trademark of Ross
Video Limited.