Cobalt Digital COMPASS 9414 4 In _ 4 Out Fiber-to-BNC Receiver _ Crosspoint Card - Manual (Page 14)

1
Technical Specifications
1-10 9400-SERIES PRODUCT MANUAL 9400S-OM (V1.1)
Technical Specifications
Table 1-1 lists the technical specifications for the 9400-series SDI/Fiber
Multi-Channel Transports with I/O Crosspoint cards.
Table 1-1 Technical Specifications
Item Characteristic
Part number, nomenclature BNC-to-Fiber Cards (Tx):
• 9401 (4 In / 1 Out BNC-to-Fiber Transmitter / Crosspoint Card)
• 9402 (4 In / 2 Out BNC-to-Fiber Transmitter / Crosspoint Card)
• 9403 (4 In / 3 Out BNC-to-Fiber Transmitter / Crosspoint Card)
• 9404 (4 In / 4 Out BNC-to-Fiber Transmitter / Crosspoint Card)
BNC-to-Fiber Cards (Tx):
• 9411 (1 In / 4 Out Fiber-to-BNC Receiver / Crosspoint Card)
• 9412 (2 In / 4 Out Fiber-to-BNC Receiver / Crosspoint Card)
• 9413 (3 In / 4 Out Fiber-to-BNC Receiver / Crosspoint Card)
• 9414 (4 In / 4 Out Fiber-to-BNC Receiver / Crosspoint Card)
Installation/usage environment Intended for installation and usage in frame meeting openGear ®
modular system definition.
Power consumption < 10 Watts maximum
Environmental:
Operating temperature:
Relative humidity (operating or storage): 32° – 104° F (0° – 40° C)
< 95%, non-condensing
Frame communication 10/100 Mbps Ethernet with Auto-MDIX.
Tx/Rx Fiber Range 40 km (24.8 mi) max
Single-Mode optics; rates thru HD:
24 km (14.9 mi) max
Fiber Connector: LC, ST, SC, or FC
Note: Connector type must be specified as part of card rear I/O
module part number. Connector types cannot be mixed on a single
rear I/O module. See Installation and Setup, Chapter 2 for more
information.
Standards Supported: SMPTE 259M-C, SMPTE 292M, SMPTE 425M, SMPTE 297M,
DVB/ASI, SMPTE 259M with EDH