Rough Country 253X - Manual (Page 15)

OPTIONAL KICKER BAR INSTALLATION INSTRUCTIONS
1. Install kicker bracket bushing and sleeves in the kicker
bars.
2. Install the supplied kicker bar brackets on the rear cross-
member as shown in Photo 1 with the supplied 1/2” x 1
1/4” bolts, flat washers and lock nuts. Tighten using a 3/4”
socket & wrench.
3. Install the kicker bar in the mount on the cross-member
with the supplied 1/2” x 3 1/2” bolts, flat washers and lock
nuts. See Photo 2. Do not tighten at this time.
4. Swing up the kicker bars and mark the hole to be drilled.
5. Drill the hole in the cross-member using a 1/2” drill bit.
6. Secure the bracket to the cross-member 1/2” x 1” bolts, flat
washers and lock nuts.
7. Swing up the kicker bar and secure to the cross-member
using the supplied 1/2” x 3 1/2” bolts, flat washers and lock nuts. See Photo 3.
Photo 2 Photo 3
Photo 1
INSTALL KICKER BRACKETS
INSTALL KICKERS INSTALL BRACKETS ON CROSS-MEMBER