beautypg.com

Rough Country 242N2 User Manual

Rough Country For the car

background image



Thank you for choosing Rough Country for all your suspension needs.

Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the product layout and kit contents
information on these instructions. Be sure you have all needed parts and know where they go. Also please review tools
needed list and make sure you have needed tools.

PRODUCT USE INFORMATION

As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur. Generally, braking performance and capability are decreased
when larger/heavier tires and wheels are used. Take this into consideration while driving. Do not add, alter, or fabricate
any factory or after-market parts to increase vehicle height over the intended height of the Rough Country product pur-
chased. Mixing component brands is not recommended.

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.

If question exist we will be happy to answer any questions concerning the de-

sign, function, and correct use of our products.

This suspension system was developed using a 31x10.5x15,
tire with factory wheels. If wider tires are used, offset wheels
and trimming will be required. This kit was developed to obtain
a front ride height of 21” on newer body style and 22” older
body style as measured from the center of the front wheel to
the bottom of the fender well. See Photo. It was also intended
to be a leveling kit—taking out the stock factory rake by raising
the rear only 1’ and raising the front 2-3”. If additional rear lift
is desired please contact your Rough Country Distributor.

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough Country product should have
a “Warning to Driver” decal installed on the inside of the windshield
or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehicle of its unique
handling characteristics.

INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.

82-04 S10 PICKUP / BLAZER & ZR2 MODELS 2.5”LIFT

921242N200

MEASURING RIDE HEIGHT

TOOLS NEEDED:

Torsion Bar Tool

Hammer

Jack Stands

Floor Jack

Wheel Chocks

Reciprocating Saw

7mm Socket / Wrench

10mm Socket / Wrench
11mm Socket / Wrench
13mm Socket / Wrench
15mm Socket / Wrench
18mm Socket / Wrench

19mm Socket / Wrench
21mm Socket / Wrench

35mm Socket

1-1/16” Socket

9/16” Socket / Wrench

Pliers