Rough Country PERF905 - Manual (Page 11)

16. Using a cutting blade remove upper control arm mounting pockets, cut the pockets flush with the inside of the uni-
body. Grind down all welds and burrs, then paint to prevent rusting. See PHOTO 13.
17. Next install one of the 94003183 flag nuts on the driver side toward the rear and one of the 94003184 flag nuts to the
front. See PHOTO 14.
18. Using 2) 7/16” x 1.25 bolts and washers, bolt the upper control arm mount to the body. Tighten using a 5/8 socket
See PHOTO 15.
19. Using the bracket as a template drill through the body on both sides with a 17/32 drill bit. Next remove the bracket
with a 5/8 socket so that the outer holes can be enlarged. See PHOTO 16.
20. With a 3/4” drill bit or a step drill bit, open up the 2 outer holes of the body so a crush sleeve can be installed. See
PHOTO 17.
21. Using 2 of the 3/4 x 3 3/8 crush sleeves insert them into the outer drilled holes. It may be required to use a hammer
to install these sleeves. See PHOTO 18.
PHOTO 14 PHOTO 13
PHOTO 18 PHOTO 17
PHOTO 16 PHOTO 15