Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 96)

96
Chapter 4 LinePrinter+ Emulation (N7000 STD)
P-Series XQ Emulation
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8, or 10.3 LPI.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends line feeds to the printer.
• CR = CR (default). Does not insert an extra line feed after each carriage
return.
• CR = CR + LF . Inserts an extra line feed after each carriage return. The
next print position will be print position 1 of the next line.
Auto LF
This option defines the printer action when print data is received past the
forms width setting.
• Disable (default). Discards any data past the forms width.
• Enable . Performs an automatic carriage return and line feed when data is
received past the forms width.
Printer
Protocol
(from page 86)
Control Code
06
Define CR
Code
Auto LF Define LF
Code
Compressed Elong/Alt.
Font
HS Print VFU Select Upr. Case
Select
Slew
Relative
8.0 LPI*
10.3 LPI
6.0 LPI
CR = CR*
CR = CR + LF
Disable*
Enable
LF = CR + LF*
LF = LF
char 01 SOH*
char 03 ETX
char 09 HT
Elng=BS Font=SO*
Elng=SO Font=BS
char 02 STX*
char 03 ETX
char 09 HT
EVFU*
DVFU
CVFU
Disable
Disable*
Enable
1-15 lines*
1-16 lines*
* = Factory Default
P-Series
XQ