Printronix N7000 H-Series Cartridge Ribbon Printer - Manual (Page 136)

136
Chapter 4 IGP/VGL Emulation
SFCC & Pwrup
This option has several sub-options which define the SFCC and power-up
configuration used with VGL.
VGL SFCC
This option selects the Special Function Control Code. The default value 5E.
Run a configuration printout to determine the currently selected VGL SFCC.
Power Up ^X
• Disable (default).
• Enable . Selects the ignore mode as the power-up default and selects the
graphics mode ^PY as the power-up default. All characters are ignored
until a ^A command is received.
Power Up ^F
• Disable (default).
• Enable . Selects free format mode as the power-up default and selects the
graphics mode ^PY as the power-up default. Free format causes the VGL
to ignore carriage returns, line feeds, and all characters below hex 20
sent from the host.
Power Up ^PY
• Disable (default).
• Enable . Selects the graphics mode ^PY as the power-up default.
LPI
The number of lines to be printed per inch. For example, at 6 lpi there is 1/6
inch from the top of one print line to the top of the next print line.
Graphics Options
The following are several options which configure printing output.
Slash 0
This parameter allows you to print the numeral “0” with or without the slash.
This option applies to all character sets except OCR-A and OCR-B.
• Disable (default). Zero is printed without a slash.
• Enable . Zero is printed with a slash.
Ignore Dots
• Disable (default).
• Enable . Causes the VGL to expect position values to be specified in only
1/10ths of an inch. If the dot position is also given, it is treated as text.