VEGA Phoenix PSI Data Fax Modem - Manual (Page 100)

PSI-DATA/FAX-MODEM/RS232
6-12 692302
&W Save Active Configuration
This command saves the active configuration in the permanent memory.
&X Synchronous Pulse Generator
The &X commands specifies the device for which the synchronous pulse generator
is available.
&Y Select Active Profile
The &Y command specifies which stored profile is loaded when the modem is
switched on or reset.
&Zn=x Store a Telephone Number in the Permanent Memory
The &Zn=x command stores a telephone number (x) (36 digits maximum) in the
permanent memory of the modem. Your modem can store up to 20 telephone
numbers (n = 0 through 20).
%D Clear Down Signal
The %D command specifies whether a Clear Down Signal is used when the
connection is aborted.
%F Full Duplex/Half Duplex
The %F command switches between half duplex and full duplex mode.
&W0 Store the active settings as configuration profile 0.
&W1 Store the active settings as configuration profile 1.
&X0 Generation of the synchronous pulse generator by the modem itself.
&X1 Accept the synchronous pulse generator of the PC or terminal.
&X2 Derive the synchronous pulse generator from the signal of the partner
modem.
&Y0 Use configuration profile 0 (default).
&Y1 Use configuration profile 1.
%D0 Disable the Clear Down function.
%D1 Enable the Clear Down function (default).
%F0 Full duplex
%F1 Half duplex mode (V.23 only)