VEGA VEGAMET 515V - Manual (Page 25)

VEGAMET 515V 25
Configuration
6.4 Fault signal
If you choose "Fault signal off“ for a certain
measurement loop, the fail safe relay and the
fault indicator LED in the front plate will not
react when a failure occurs on this measure-
ment loop, e.g. in case of short-circuit. Fail-
ures on other measurement loops, however,
will be signalled.
Only if on all measurement loops "Fault signal
off“ is selected will the fail safe relay and the
fault indicator LED be completely out of op-
eration.
6.3 Measurement loop name
Naming the measurement loop
You can modify the measurement loop name
"TAG-No. 1“, if you want a more meaningful
designation.
Two lines with six figures each are available.
To do this, move to the menu item "TAG name
…“.
Push [+] or [–] once. The first char-
acter of the measurement loop
name, in this example the letter T,
flashes (editing mode). Continue
pushing the [+] or [–] key, by doing this you
scroll through the alphabet, through the row
of numbers and through a list of characters.
When you have reached the re-
quested character, push [–>]. The
next character is activated and be-
gins to flash. Scroll again with [+] and
[–] to the requested character. With [–>] you
move to the next character.
When you have finished the last posi-
tion of the name and "written" the
name of the measurement loop in this
way, you have to push [OK] to save
the setting. If you quit the menu item without
saving, the name of the measurement loop
will be still "TAG-No. 1“.
In the display of measured value and
all other menu items in which the
measurement loop name is stated,
you will now find the new designation.
TAG-
Name
T
A G -
No. 1
TAG-
Name
Ves.4
Hall
3
Ves.4
Hall3
%
27,8
TAG-
Name
T AG -
No. 1