VEGA VEGAMET 515V - Manual (Page 18)

18 VEGAMET 515V
In the menu items "Pos. D“ and "Pos. E“ you
can determine if "Correction input 4“ or "Cor-
rection input 5“ is to be used for one of the
stated corrections. You then have to enter
under "Parameter adjustment“ – "Special
functions“ in the menu items "Real value cor-
rection at…“ or "Density correction at…“ a
value at which the correction should be car-
ried out.
Note!
For tare and monitoring it is also possible to
assign input 4. However, a correction input
must not be used for tare, monitoring and
e.g. density correction at the same time!
In the menu item "TAG-Name“ you can enter
an individual name for the measurement loop.
If you choose "Fault signal off“, the fail safe
relay and the fault indicator LED in the front
plate do not function. For a description of the
correction modes, see the following pages.
Configuration
Level measurement
Gauge measurement
Distance measurement
Pos. A Pos. A
Two independent single measurements
Pos. A
Pos. A
Pos. A Pos. A
Pos. A Pos. A Pos. A