Velleman VMB1TC - Manual (Page 49)

VMB1TC Temperature controller manual – rev 5.0 49
Defining zones
It could be interesting to group different sensors in a zone. When that zone is selected, all operations on the controller will
be applicable for all sensors that belong to that zone. This way operating the system can be greatly facilitated.
It is possible to define up to 7 zones e.g. ground floor, second floor, bedrooms …
Default temperature sensors are not assigned to a zone. To assign them to a zone the procedure below should be
followed.
1. Press the ‘Location’ button repeatedly until the
sensor that will to be added to a zone is displayed.
2. Press and hold the ‘Menu’ button for ±4 seconds to
open the extended menu.
3. Scroll through the extended menu using the ↑ or ↓
button until the ‘Sensor settings’ item appears.
4. Select the sensor settings menu with the → button.
5. Scroll through the sensor settings menu using the ↑
or ↓ button until the ‘Zone number’ item appears
6. Select the zone number menu with the → button.
7. Change the zone with the ↑ or ↓ button.
Option ‘---‘ indicates that the sensor does not belong
to a zone.
8. Confirm with the → button.
Location
5
↑
↓
Menu
→
Mode
←
Bedroom
Zone 1
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
Mo 14:32 16
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
Program
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
Sensor settings
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
Operating mode
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
Zone number
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
________
Location
5
↑
↓
Menu
→
Mode
←
Bedroom 1
Zone number