Velleman VMB1TS - Manual (Page 33)

VMB1TS manual – edition 2 33
Remotely lock local operation
With the upper right button on the second page of the control panel locally operating the temperature sensor can be
disabled.
1. Remember the address of the sensor module to
reinstate it later.
2. Set the address of the sensor module to ‘91’.
All LEDs are flashing to indicate learning mode for
pushbuttons that lock local operation.
Remark:
When multiple sensor modules need to react to the
same pushbutton, remember their addresses and
set them also to ‘91’.
3. Select the second page of the control panel by
pressing the small pushbutton.
4. Press and hold the ‘Lock’ pushbutton
(at least 1 second) until its indication LED starts
flashing.
Remark:
As long as the pushbutton is pressed, the LEDs on
the sensor module will be off. This to confirm that
the pushbutton is assigned.
5. Repeat step 4 in case other pushbuttons must
disable local operation of the sensor.
6. Reinstate the address of the sensor module(s) to
its (their) original value.
ADDR = 91
Heating Lock
Cooling Unlock
Heating Lock
Cooling Unlock