Velleman VMB1TS - Manual (Page 30)

30 VMB1TS manual – edition 2
Remotely control anti-freeze mode
With the lower right button of the control panel the temperature sensor is set to anti-freeze mode.
1. Remember the address of the sensor module to
reinstate it later.
2. Set the address of the sensor module to ‘C1’.
The day, night and comfort LEDs are flashing to
indicate learning mode for pushbuttons that place
the module in anti-freeze mode.
Remark:
When multiple sensor modules needs to react to
the same pushbutton, remember their addresses
and set them also to ‘C1’.
3. Press and hold the ‘anti-freeze’ pushbutton
(at least 1 second) until its indication LED starts
flashing.
Remark:
As long as the pushbutton is pressed, the LEDs on
the sensor module will be off. This to confirm that
the pushbutton is assigned.
4. Repeat step 3 in case other pushbuttons must set
the sensor module in anti-freeze mode.
5. Reinstate the address of the sensor module(s) to
its (their) original value.
ADDR = C1
Comfort Day
Night Anti-freeze