Velleman VMB1TS - Manual (Page 28)

28 VMB1TS manual – edition 2
Remotely control day mode
With the upper right button of the control panel the temperature sensor is set to day mode.
1. Remember the address of the sensor module to
reinstate it later.
2. Set the address of the sensor module to ‘E1’.
The day LED is flashing to indicate learning mode
for pushbuttons that place the module in day mode.
Remark:
When multiple sensor modules needs to react to
the same pushbutton, remember their addresses
and set them also to ‘E1’.
3. Press and hold the ‘day’ pushbutton
(at least 1 second) until its indication LED starts
flashing.
Remark:
As long as the pushbutton is pressed, the LEDs on
the sensor module will be off. This to confirm that
the pushbutton is assigned.
4. Repeat step 3 in case other pushbuttons must set
the sensor module in day mode.
5. Reinstate the address of the sensor module(s) to
its (their) original value.
ADDR = E1
Comfort Day
Night Anti-freeze