Spicer Drive Axles Service Manual Wheel Reduction Drive Axles (EA-50) - Manual (Page 5)

3
MODEL IDENTIFICA MODEL IDENTIFICA MODEL IDENTIFICA MODEL IDENTIFICA MODEL IDENTIFICATION NUMBERING SYSTEM TION NUMBERING SYSTEM TION NUMBERING SYSTEM TION NUMBERING SYSTEM TION NUMBERING SYSTEM
GEAR SET IDENTIFICA GEAR SET IDENTIFICA GEAR SET IDENTIFICA GEAR SET IDENTIFICA GEAR SET IDENTIFICATION TION TION TION TION
Man Man Man Man Manufactur ufactur ufactur ufactur ufacturer's Da er's Da er's Da er's Da er's Dattttte- e- e- e- e- Date gear set was made.
Spicer T Spicer T Spicer T Spicer T Spicer Trrrrrademark ademark ademark ademark ademark- - - - - Company logo and location of
manufacturing facility.
3 3 3 3 300GP2 00GP2 00GP2 00GP2 00GP20 0 0 0 03- 3- 3- 3- 3- Part number of pinion gear. (TYPICAL)
T T T T Too oo oo oo ooth Combina th Combina th Combina th Combina th Combination(i.e. 4 tion(i.e. 4 tion(i.e. 4 tion(i.e. 4 tion(i.e. 41-1 1-1 1-1 1-1 1-11)- 1)- 1)- 1)- 1)- Indicates the pinion
has 11 teeth and the ring gear has 41 teeth which
results in a 3:73:1 ratio.
Ma Ma Ma Ma Matched Se tched Se tched Se tched Se tched Set Number t Number t Number t Number t Number- - - - - Spicer ring gears and pinions
are manufactured as matched sets. Both ring gear and
pinion are marked with a corresponding number (i.e.
260), which identifies them as a matched set.
A gear set that does not have the same match set
numbers should not be run together. If either ring gear
or pinion require replacement, a new matched set must
be used.
Backla Backla Backla Backla Backlash Etch- sh Etch- sh Etch- sh Etch- sh Etch- Indicates backlash setting for assembly.
Pinion Etch- Pinion Etch- Pinion Etch- Pinion Etch- Pinion Etch- Indicator for proper pinion position shim
stack up. See Pinion P
See Pinion P See Pinion P See Pinion P See Pinion Position Section. osition Section. osition Section. osition Section. osition Section.
HEAT
CODE
SPICER
TRADEMARK
MFG.
DATE MATCHED
SET NUMBER
PART
NUMBER
TOOTH
COMBINATION
41-11
260
SPICER
TRADEMARK
+15
L10
PINION ETCH
BACKLASH ETCH
260
Options
(N = *No-SPIN
® Differential)
(L = Driver Controlled Diff. Lock)
(B = Bus)
S 230 S L
Gearing Type
(S = Single Reduction) Family
(S = Spicer) Nominal Load
Carrying Capacity
(230 = 23,000 Lbs.)
(260 = 26,000 Lbs.)
* No-SPIN ® is a registered trademark of Tractech