Ohaus CD-11 Indicator Manual multi - Manual (Page 14)

EN-8 CD-11 Indicator
2.6 Initial Setup
The CD-11 Indicator is equipped with menus which permit certain functions to be locked out (not changed)
during operation. If locking out changes to the setup selections, access the CAL jumper located on the circuit
board following the setup procedure. Once all setup procedures are completed, reassemble the Indicator. For
first time setup, step through all menus and set the parameters as desired. As the last step, enter the CAL menu
and calibrate the system.
The Indicator has five menus; CAL (Calibration), SEtuP (Setup), rEAd (Read) , Print (Printing) and LOCSW
(Lockswitch) which are entered by pressing and holding the G/N/T/
Menu button until MEnu is displayed, then
releasing it. The display then switches to CAL.
To access the rest of the menus, the PRINT/ Units button is repeatedly pressed until the desired menu is
reached.
2.6.1 Control Functions
During setup, the following buttons are used.
PRINT/ Units Button
Change between menus horizontally or change sub-menu parameters.
G/N/T/ Menu Button
Press and hold to enter menu. Enters menu and steps through sub-menus vertically.
Tare Button
Change print interval settings.
2.5.3 Switching On the Indicator
Once the Indicator and Scale Base are connected and installed, follow the setup procedure outlined below.
Power On/Off
With the Indicator connected to an appropriate power supply, press the ON/ZERO Off button. The Indicator
performs a self-test, displays the software revision momentarily and then goes to a weighing mode.
At this point, the Indicator is on and ready for initial setup.
Stabilization
Before initially using the Indicator, allow time for it to adjust to its new environment. Recommended warm up
period is five (5) minutes.
NOTE: It is recommended that when the CD-11 is operated from batteries, the Auto-Off Timer feature be turned
on to extend battery life.
2.5.2 Battery Installation (Cont.)