Ohaus CD-11 Indicator Manual multi - Manual (Page 11)

EN-5 CD-11 Indicator
2. INSTALLATION
2.1 Unpacking and Checking
Open the package and remove the instrument and the accessories. Check the completeness of the delivery.
The following accessories are part of the standard equipment of your new Indicator.
Remove packing material from the instrument.
Check the instrument for transport damage. Immediately inform your Ohaus dealer if you have complaints or
parts are missing. Your Indicator package should contain:
• Indicator CD-11
• AC Adapter
• Warranty card
• Capacity label
• Screw driver (for terminal connections)
• Instruction Manual
• Sealing Kit
• RS232 connector
Store all parts of the packaging. This packaging guarantees the best possible protection for the transport of
your instrument.
2.2 Selecting the Location
The Indicator should be used in an environment which is free from corrosives, vibration, temperature or
humidity extremes. These factors will affect displayed weight readings. Scale bases used with the Indicator
should be located on a stable level surface and kept away from vibrating sources such as large machinery.
Maximum accuracy will be achieved when the area is clean and vibration free.
2.3 Connecting the Indicator to a Scale Base
Turn the Indicator over and using a Phillips screw driver, remove the four screws which secure the rear cover.
Two screws are under the battery cover.
Remove the rear cover.
Pass the load cell cable through the liquid tight connector on the left side of the housing.
Refer to the color code of the load cell cable and connect the wires to Terminal Strip J4. Tighten all screws
securely.