Quit – Ohaus CD-11 Indicator Manual multi User Manual

Page 15

EN-9

CD-11 Indicator

2.6.2 Menu Structure

The following table illustrates the menu structure in the CD-11 Indicator.

MAIN MENU

CAL

SEt uP

rEAd

Print

LOCSW

CALIBRATION

SPAN Y

LIN Y

GEO (Value)
GEO 0...gEO 12...
GEO 31

Save Settings
SAVE

Legal for Trade
LFtOFF, LFtOn,,,,, LFtCan

Zero (Range)
0 2 (2%),
0 18 (18%),
0 100 (100%)

Calibration Unit
CAL Un kg,
CAL Un lb

Full Scale
capacity
F 5, to....... F20000

Graduation Size
gd0.001, to ....gd 20

Calibration Point
CP 5, to....C20000

Save Settings
SAVE

* Reset rEAd menu to
factory defaults
rESEtn (no), rESEtY (yes)

* Averaging Level
AL LO, AL HI

* Stability Level
StAb0.5 (0.5d),
StAb1 (1d), StAb3 (3d)

*Unit of Measure
Un OFF g, Un On g,
Un OFF lb, Un On lb,
Un OFF kg, Un On kg,
Un OFF oz, Un On oz,

Alternate Mode
ALtOFF, (none)
ALtPC (Parts counting),
ALtdH (Display hold)

(If ALtdH is selected, set
display hold type)
dHMAn (manual),
dHSEM (semi-automatic),
dHAuto (Automatic)

*Auto Zero Tracking
AZt 0.5 (0.5d), AZt 1 (1d),
AZt 3 (3d)

*Auto Off Timer
AOtOFF, AOt On

*Retain Zero Data
rZdOFF, rZd On

Backlight
bLAuto, bL On, bL OFF

EP (Service mode)
EP OFF or EP On

* Save Settings
SAVE

* Reset Print menu to
Factory defaults
rESEtn (no), rESEtY (yes)

* Baud Rate
bd1200, bd2400, bd4800,
bd9600, bd19,200

*Parity
PAr nO (none),
PAr Odd (odd),
PAr E (even)

*Data Length
dAtA 7, dAtA 8

*Stop Bit
StOP 1, StOP 2

Auto Print mode
AP OFF, APCont, AP Int,
AP StbL

If AP Int is selected, set
Auto print interval
Int 0001 to 3600

Only print data when
stable
StbOFF, Stb On

* Save Settings
SAVE

Lock SEtUP menu
LStOFF, LST On

* Lock rEAd menu
LrdOFF, Lrd On

* Lock Print menu
LPtOFF, LPtOn

Lock CAL menu
LCLOFF, LCL On

* Save Settings
SAVE

123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678901

Press (G/N/T/

MENU ) to enter the display submenu or select a displayed setting.

Press (PRINT/

UNITS ) to change the displayed submenu or setting.

Factory default settings are shown in underlined and boldface type.

When jumper (CAL) on the circuit board is opened, all of the menus can be reached except CALIBRATION
Menu, but only the submenus which are marked ' * ' can be setup, see menu structure.

Quit

(Exit to

weigh mode)