Ohaus GT4100DG Electronic Balances - Manual (Page 44)

44
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
P P P P P Print display data
When “numeric only” display
data is selected for output in
the RS232 menu, the Mode
field is not output.
xS xS xS xS xS Set stable data only printing (set x = 0 for OFF, or x = 1 for ON).
T T T T T Same effect as pressing rezero button
V V V V V Print EPROM version
xZ xZ xZ xZ xZ Set Auto Zero to “x”,
where x = 0 to 3 (see table).
x% x% x% x% x% Downloads reference weight “x” for percent mode. “x” must be in grams.
Command is ignored if percent mode is disabled. If percent mode is enabled,
balance will automatically switch to percent mode display.
Esc L Esc L Esc L Esc L Esc L Prints listing of Setup and Print menu settings.
Esc R Esc R Esc R Esc R Esc R Resets Setup and Print menus to factory defaults.
CAUTION: This will reset RS232 configuration.
Esc S Esc S Esc S Esc S Esc S Save current settings.
Field: Weight Mode Stab CR LF
Length: 9 1 5 1 1 1
Same as ?
command
Displayed weight sent right justified
w/lead zero blanking.
Nine characters include:
decimal point (1)
weight (7 max))
polarity (1): blank if positive
“ - ” if negative
Field: Model # EPROM # CR LF
Length: 7 15 1 1
0 = OFF
1 = .5 d
2 = 1 d
3 = 3 d
Balance Model
"98101-XX Sr*XX.X"