List, Print menu – Ohaus GT4100DG Electronic Balances User Manual

Page 32

List

This submenu can be used to output a listing of current menu settings via the RS232
interface. When selected, all menu settings for the User, Setup and Print menus will
be output either to an external printer or computer. To use this feature, your balance
must be connected to a computer or printer.

1. Access the

menu under the Print menu.

to obtain a listing of current settings. The display

indicates a series of dots traveling right to left when the balance is sending

information

PRINT OPTIONS

Auto Print

Cont, interval,
on stb,off

off

Initialize Auto Print

Interval, non print lo,
non print hi

Stable Data

ON/OFF

OFF

Numeric Data

ON/OFF

OFF

Time

ON/OFF

OFF

Date

ON/OFF

OFF

Reference

ON/OFF

OFF

End, Print Options

LIST

END, PRINT

PRINT MENU

RESET

YES

YES/NO

COMMUNICATION

Baud
300, 1200, 2400

2400

2400,

4800, 9600

Data Bits
7

7 or 8

Parity Bit
Odd, Even, None

None

None,

1, 0

Stop Bits
1 or 2

End, Comm.

GLP

ID #
Project #
End,GLP

PRINT MENU

The Print menu provides a number of options which includes: reset, communications,
good laboratory practices, and list.

Reset

sets all submenus contained in the Print

submenu to factory default settings.

Communication

specifies baud rate, number of

data bits, parity bit type and stop bits.

GLP

Good laboratory practices permits the

entering of your own identification number and project number which shows up on
printing.

Print Options

Enables/disables Auto print feature, specifies time interval for

automatic output of displayed data and/or a range of displayed weight values that
cannot be output. The following items can be turned on or off: Stable data-only feature,
numeric only or full display data for output, time and date. Items shown in bold type are
default settings. Items shown in italics in the print menu below appear only if the
appropriate Functions are turned on. Items shown in bold type are the default settings.