Ohaus GT4100DG Electronic Balances - Manual (Page 27)

27
Unit Selection Unit Selection Unit Selection Unit Selection Unit Selection
The Unit Selection (SEL) submenu permits the selection of weighing units for use
during operation. The balance can display weights in every unit of measure listed
shown below. The default setting is shown in bold type.
g g g g g Grams Grams Grams Grams Grams
oz Ounces
lb Pounds
To view or change the various weighing units:
1. Access the menu.
2. to select first unit .
3. to select or , next unit
status is displayed.
4. Set each unit ON or OFF by repeating steps 2 and 3.
5. .
Type Approved/LFT Type Approved/LFT Type Approved/LFT Type Approved/LFT Type Approved/LFT
LFT can be set to ON or OFF. Selecting ON automatically sets the parameters shown
in the table to conform to type approved requirements. For sealing method, refer to
Type Approved Sealing section. Default setting are shown as follows:
Auto Zero .5 d
Lockswitch Setup & Calibration
Stable Data Locked ON
1. Access the submenu.
2. .
3. to select or .
4. .