Ohaus GT4100DG Electronic Balances - Manual (Page 36)

36
Good Laboratory Practice (GLP) (Cont.) Good Laboratory Practice (GLP) (Cont.) Good Laboratory Practice (GLP) (Cont.) Good Laboratory Practice (GLP) (Cont.) Good Laboratory Practice (GLP) (Cont.)
NOTE NOTE NOTE NOTE NOTE: allows going back to the previous digit for correction.
8. To enter project number, repeat steps 2 through 6, except enter
submenu.
Print Options Print Options Print Options Print Options Print Options
This submenu contains additional features which can be set and include Auto Print,
Initialize Auto Print, Stable Data, Numeric Data, Time, Date and Reference data.
To change any of the above listed options, enter the submenu.
Auto Print Feature Auto Print Feature Auto Print Feature Auto Print Feature Auto Print Feature
When enabled, the Auto Print feature causes the balance to automatically output
display data in one of three ways: continuously, at user specified time intervals, or upon
stability.
To select one of these Auto Print methods, or to turn the feature off:
1. Access the submenu.
2. to accept current setting.
3. , , or
.
4. .
NOTE NOTE NOTE NOTE NOTE: If you select interval to automatically output data at user specified time
intervals, the interval is entered in the Initialize submenu which follows.
Initialize Initialize Initialize Initialize Initialize
This submenu allows you to:
•
Specify a time interval (in seconds) for automatic output.
•
Exclude a range of weights from being output, or specify a range for output, by the
Auto Print feature.
It does not appear on the Print menu if Auto Print is set to OFF. Use the following
procedure to set these features: