Ohaus GT4100DG Electronic Balances - Manual (Page 43)

43
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
? ? ? ? ? Print current mode
nnnA nnnA nnnA nnnA nnnA Set Auto Print feature to “nnn”
(see table).
C C C C C Begin span calibration
xD xD xD xD xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
E E E E E Exit percent weighing, FM
x x x x x IIIII Set Averaging Level to “x”,
where x = 0 to 3 (see table).
L L L L L Begin linearity calibration
M M M M M Same effect as pressing mode button
xM xM xM xM xM Places balance in mode “x”,
where x = 1 to 13 (see table).
If unit or mode is not already
enabled, command will be ignored.
RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE
Field: Mode Stab CR LF
Length: 5 1 1 1
blank if stable
“ ? ” if unstable
1 = grams
2 = ounces
3 = pounds
nnn = 0 Turns feature OFF
nnn = S Output on stability
nnn = C Output is continuous
nnn = 1-256 Sets Auto Print
Interval
0 = minimum level
1 =
2 =
3 = maximum level
Grams g
Pounds lbs
ounces oz