Ohaus GT4100DG Electronic Balances - Manual (Page 24)

24
Auto-Zero Auto-Zero Auto-Zero Auto-Zero Auto-Zero
Auto-Zero minimizes the effects of temperature changes and shift on the zero reading.
By defining a threshold level in divisions, the balance maintains the zero display until
the threshold is exceeded. Factory default setting is shown in bold type.
OFF Turns Auto-Zero OFF.
.5 d .5 d .5 d .5 d .5 d Sets threshold to .5 divisions. Sets threshold to .5 divisions. Sets threshold to .5 divisions. Sets threshold to .5 divisions. Sets threshold to .5 divisions.
1 d Sets threshold to 1 division.
3 d Sets threshold to 3 divisions.
To view or change the auto-zero setting:
1. Access the Auto-Zero submenu.
2. .
3. to select through .
4. .
Beep Function Beep Function Beep Function Beep Function Beep Function
A beep (sound) feature is a tone or series of tones emitted to annunciate various
balance conditions. The table below defines when the beeps are sounded if turned ON.
The default setting for the Beep menu is OFF. To turn the sound feature ON, proceed
as follows:
1. Access the submenu.
2. .
3. to select or .
4. .
GT BEEPS GT BEEPS GT BEEPS GT BEEPS GT BEEPS
Power-On Single long beep (Plug in, not front panel On) Single long beep *
Key Press Single short beep
Reset in Menu Double short beep *
* Indicates that the beep cannot be disabled.