Ohaus GT4100DG Electronic Balances - Manual (Page 38)

38
Initialize (Cont.) Initialize (Cont.) Initialize (Cont.) Initialize (Cont.) Initialize (Cont.)
11.After the last digit is entered, is displayed again.
for the NON-PH high limit.
12 to view the current value for the high end of the range.
13.Change the number as needed using the same procedure as in step 9.
14.After the last digit is entered, displayed again.
15. .
16. .
Print Stable Data Only Print Stable Data Only Print Stable Data Only Print Stable Data Only Print Stable Data Only
When enabled, this feature permits only stable display data to be output. To set the
feature ON or OFF, proceed as follows:
1. Access the submenu under the Print Options menu.
2. to accept.
3. to select or .
4. .
Print Numeric Data Only Print Numeric Data Only Print Numeric Data Only Print Numeric Data Only Print Numeric Data Only
This submenu is used to select numeric data only, or full display data for RS232 output.
Set this feature ON to output numeric display data only, or OFF to output full display
data as follows:
1. Access the submenu under the Print Option menu.
2. to display the current status.
3. to select or .
4. .