1 how to restore a file, How to restore a file, Ow to – EVS Xfile Version 2.14 - January 2011 User Manual User Manual
Page 82: Estore a

XFile Version 2.14 – User Manual
EVS Broadcast Equipment – January 2011
Issue 2.14.B
73
3.7.1 H
OW TO
R
ESTORE A
F
ILE
To restore a backed up file on an EVS video server, proceed as follows:
1. Click the Restore button to activate the mode.
2. Select the clip from the XFile list.
3. Select the server from the XNet area: to display the list of servers present
on the XNet, click
.
4. Change the display of the list to find one location where to restore the clip.
To specify this location, select the page, the bank and the camera
selection :
•
To display the page/bank list, click
.
•
To display the list of cameras, click
.
5. Select an available location in the XNet list.
6. To restore the clip to the location specified on an EVS video server, do one
of the following:
•
Click
(RESTOREclip) to initiate the transfer of the selected clip. The
UmID (ID-material/ID-louth) is preserved.
•
Click
(COPYclip) to initiate the transfer and to create a COPY of the
selected clip. In this case a new UmID is defined.
To ensure the validity of data during operations, only one UmID can be
present on the same network. Then if the operator has to use identical
clips on several machines, the COPYclip command is advised to restore
several versions of the same clip.
•
Click
(Short COPYclip) to initiate the transfer of a shorter copy of the
selected clip. Only the V/A material included between the IN and the OUT
points (without guardbands) will be restored. In this case, a new
IDmaterial and a new IDlouth are defined.