Dell OptiPlex GX240 - Manual (Page 61)

A d v a n c e d Fe a t u r e s 59
3 When the system setup screen appears, press to load the
Dell default settings.
The computer beeps when the settings are restored.
NOTE: Verify that
the time, date, and year
are corect and that the
Secondary Drive 0 option
is set to
Auto.
4 Press and then press to save your changes and exit.
The computer reboots.
Jumper Settings
The following figure shows the jumpers on the system board.
S y s t e m B o a r d J u m p e r s
NOTICE: Make sure that your computer is turned off and unplugged before
you change the jumper settings. Otherwise, damage to your computer or
unpredictable results may occur.
To change a jumper setting, pull the plug off its pin(s) and carefully fit it
down onto the pin(s) indicated.