Dell OptiPlex GX240 - Manual (Page 128)

126 I n s t a l l i n g U p g r a d e s
www
.dell.com | support.dell.com
Detaching Floppy Drive Cables
1 Disconnect the cables from the floppy drive and system board.
2 Disconnect the CD/DVD drive cable and the power cable from the
CD/DVD drive.
3 On the small form-factor computer, remove or raise the drive by
pressing the green tabs on either side of the drive and lifting the drive
up.
a Remove the interposer board from the floppy drive by pressing the
tab and rotating the interposer board.
S m a l l Fo r m - Fa c t o r C o m p u t e r
b To release the cable from the connector, slide the lever until it is
fully extended and then lift the cable away.
1 floppy drive cable
2 tab
3 interposer board
4 system board floppy drive connector (DSKT)
or
1
3
4
2
or
1
3
4
2