ACU-RITE 200S - Manual (Page 57)

200S 43
I - 3 Milling Specific Oper
ations
Incline Milling Form Entry
The Incline Milling form is used to specify the flat surface to be milled.
The data is entered in the “Incline Mill Form”. Select INCLINE MILL
soft key to define the feature. The following listed fields require data
input.
„ Plane: Select the plane by pressing the PLANE soft key. The current
selection is shown on the soft key and in the plane field. The graphic
in the message box aids in selecting the correct plane.
„ Start Point: Enter the coordinates of the start point, or press
TEACH to set the coordinate to the current position.
„ End Point: Enter the coordinates of the end point, or press teach to
set the coordinate to current position.
„ Step: Enter the step size. When milling, this is the distance
between each pass or each step along the line.
Press the ENTER key to close the form and execute the feature. Press
C hard key to exit the form without saving the feature.
The Step size is optional. If the value is zero, the operator
decides at run-time how far to move between each step.
The entries are saved to memory. They will stay in memory
until deleted, or changed, and are not affected by a
power cycle.