ACU-RITE 200S - Manual (Page 47)

200S 33
I - 3 Milling Specific Oper
ations
Preparation:
8 Select the tool with the appropriate tool data.
8 Pre-position the tool to an appropriate location (such as X = Y = -1”).
8 Move the tool to milling depth.
8 Press the PRESET soft key.
8 Press the Y axis key
-ALTERNATIVE METHOD -
8 Press the SET/ZERO soft key so that you are in Set mode.
8 Press the Y axis key.
8 Enter nominal position value for corner point 1: Y = 1”, and select
tool radius compensation R + with R+/- soft key. Press until R+ is
shown next to axis form.
8 Press ENTER.
8 Traverse the Y axis until the display value is zero. The square in the
near zero warning is now centered between the two
triangular marks.
8 Press the PRESET soft key.
8 Press the X axis key.
-ALTERNATIVE METHOD -
8 Press the SET/ZERO soft key so that you are in Set mode.
8 Press the X axis key.
8 Enter nominal position value for corner point 2: X = 1.5” select tool
radius compensation R - with R+/- soft key. Press twice until R- is
shown next to axis form.
8 Press ENTER.
8 Traverse the X axis until the display value is zero. The square in the
near zero warning is now centered between the two
triangular marks.
8 Presets can be entered in the same manner for corners 3, and 4.