ACU-RITE 200S - Manual (Page 27)

200S 13
I - 2 Gener
a
l Oper
ations f
o
r 20
0S
Job Setup Parameters
8 To view and change Job Setup parameters, first press the SETUP
soft key.
8 Use the UP/DOWN arrow keys to highlight the parameters
of interest.
8 press the ENTER key.
The Job Setup Data can be imported, or exported using the
IMPORT/EXPORT soft key.
Exporting the current Job Setup:
8 Press the SETUP soft key.
8 Press the IMPORT/EXPORT soft key.
8 Press the EXPORT soft key.
Importing a new Job Setup Table
8 Press the SETUP soft key.
8 Press the IMPORT/EXPORT soft key.
8 Press the IMPORT soft key.
Units
The Units form is used to specify the preferred display units and
format. You can also select the unit of measure by pressing the
INCH/MM soft key in either Actual Value or Distance-To-Go mode.
Scale Factor
The scale factor may be used to scale the part up or down. A scale
factor of 1.0 creates a part with the exact size as dimensioned on the
print. A scale factor >1 “grows” the part, and <1 “shrinks” the part.
„ The numeric keys are used to enter a number greater than zero. The
number range is 0.1000 to 10.000. A negative value may also
be entered.
„ The scale factor settings will be retained on a power cycle.
„ When the scale factor is a value other than 1, the scaling symbol
is shown on the axis display.
„ The ON/OFF soft key is used to disable the current scale factors.