Acroprint ATR440 Payroll Recorder User Manual

Page 6

2.3 Installation
The ATR 440 can be installed in any normal office environment. No

special wiring is needed. However, we recommend installing the ATR

440 on a separate power circuit. We do not recommend using a power

strip. Always follow basic safety precautions when using this product

to reduce risk of injury, fire, or electric shock.

Caution:

Read and understand all instructions in the ATR 440 User's

Manual before installing and operating this time recorder.

Do not install the ATR 440 in areas where it may be exposed to

direct sunlight or high temperatures, such as near a heater.

Do not install the ATR 440 where it may be exposed to

excessive dust or to high humidity, resulting in condensation.

Do not use this product near water or when you are wet. If the

product comes in contact with any liquids, unplug the line cord

immediately. Do not plug the product back in until it has been

thoroughly dried.

Securely install the time recorder on a stable, level surface, or

if wall mounting the ATR 440, follow the mounting

instructions to install it securely on the wall. Place the time

recorder where no one can step or trip over the cord. Do not

place objects on the cord that may cause damage or abrasion.

If this product does not operate normally, please see the

Troubleshooting section of this manual.

2.4 Wall mounting
Place the top screw approximately 44 to 46"

above the floor. Using the enclosed mounting

template, install the other two screws as

indicated.

Hook the unit on the screws through the holes

on the back cover.

Setup

atr440 A5 paper size.p65

8/21/02, 8:16 AM