Acroprint ATR440 Payroll Recorder - Manual (Page 26)

26
Next, you need to program the OUT. You will need to change the
position code to the correct position code. Use the + or - buttons
to change the position code. Press the E button to accept the
position code.
The hour the auto-shift change should take place flashes next.
Press the + or - button to change the hour. When finished, press
the E button to accept the hour setting.
The minute the auto-shift change should take place at flashes
next. If necessary, press the + or - button to change the minute.
Press the E button to accept the minute setting.
The day of the week will flash. Choose Sunday if the auto-shift
setting should apply to each day. Use the + or - button to change
the day. Press the E button when complete to register the auto-
shift setting. When the next program number appears, the
registration is complete.
You may either close the top cover at this time or continue to set
auto-shift schedules or other settings.
Confirming or changing the IN/OUT auto-shift times
Open the top cover. The digital display reads P1.
Press the PRO button, the display will read P2.
Press the F5 button. The display will show the
time and date you entered for the first programmed group. The
position code is the two characters on the left on the display.
To confirm the first auto-shift setting, press the F5 button to
move to the next setting. Continue moving through the settings
by using the F5 button until you locate a setting you want to
change. Press the + and - button at the same time to delete the
information entered for that setting. Then enter the correct time
for the auto-shift. Close the top cover when you have finished
confirming auto-shift settings.
Settings
atr440 A5 paper size.p65 8/21/02, 8:16 AM 26