Acroprint ATR440 Payroll Recorder - Manual (Page 20)

20
3.8 Setting the day change time
Currently, the day change time is set to 00:00 or midnight. The day
change time is the time a new day begins. The day of the week
indicator and the date shown on the digital display always changes at
midnight. The day change time only affects where the time will print
on the time card.
Open the top cover. The digital display reads P1.
Press the PRO button, the display will read P2.
Press the F1 button.
Press the + or - button to change the day change time. The hours
flash first. Once the hour of the change is set, press the E button
to accept it. The minutes will flash next. Press the + or - button
to change the minutes. Press the E button when the minutes have
been set.
The display will turn off. You may either close the top cover at
this point or continue setting the clock.
3.9 Setting signal duration
The default length for a signal is five seconds; however, the signal
may last up to 99 seconds. The length of the signal may be changed as
needed.
Open the top cover. The digital display reads P1.
Press the PRO button, the display will read P2.
Press the F2 button.
The length of the signal flashes on the display. Use the + or -
button to change the duration in seconds of the signal. Press the
E button to accept the signal duration setting.
Settings
atr440 A5 paper size.p65 8/21/02, 8:16 AM 20