Acroprint ATR440 Payroll Recorder - Manual (Page 31)

31
7. Removing & installing the case
To remove the case:
1) Open the top cover by
inserting the key into the
keyhole and turning it
clockwise.
2) Use a Phillips (+) screwdriver
to remove 2 screws (A and B
in Figure 5).
3) Lie the time recorder on its
back.
4) Use a Phillips (+) screwdriver
to remove 2 screws
(Figure 6).
To remove the back cover:
1) Use a small slotted (-) screw
driver to remove the plastic
rivet (A). Remove the display
PC board. (Figure 7)
2) Use a Phillips (+) screwdriver
to remove 2 screws. (B in
Figure 7)
3) Turn the time recorder
around.
4) Use a Phillips (+) screw
driver to remove screws C
and D. (Figure 8)
5) Remove the back cover by
pulling it towards you.
6) To reinstall the back cover,
reverse the steps above.
Removing and installing the case
atr440 A5 paper size.p65 8/21/02, 8:16 AM 31