Accusys Acuta User Manual
Page 64
Accusys Acuta User’s Manual
64
A
A
p
p
p
p
e
e
n
n
d
d
i
i
x
x
D
D
U
U
U
p
p
p
d
d
d
a
a
a
t
tt
i
ii
n
n
n
g
g
g
F
F
F
i
ii
r
rr
m
m
m
w
w
w
a
a
a
r
rr
e
e
e
The ACUTA 4/4S is shipped with firmware installed. You may however wish to install new or
upgraded editions of the firmware. Ask your vendor about the latest firmware edition or refer
to the Accusys website http://support.accusys.com.tw
Once new or updated firmware has been obtained, it can be downloaded to ACUTA 4/4S from
a host PC with third party communication software, such as HyperTerminal, that supports
ANSI terminal emulation. Other terminal programs may be used in place of HyperTerminal to
communicate with ACUTA 4/4S. However, the setup process for other terminal software may
differ from that outlined in this chapter.
Array data and configurations are not affected by updating of firmware.
HyperTerminal is bundled as standard with Microsoft Windows operating
systems. It will be found in the Communications folder. The program can also
be downloaded from Hilgraeve Software at http://www.hilgraeve.com/htpe/
1. Ensure ACUTA 4/4S is turned off.
2. Connect one end of the supplied RS-232
cable to the RS-232 port on the rear of
ACUTA 4/4S and connect the other end to
one of the host computer’s COM ports.
格式化: 非醒目提示
註解 [V21]: replaced the
photo