Accusys Acuta - Manual (Page 27)

Chapter 3 – Setting up the subsystem
27
1. Pull the drive carrier handle to release
the latch.
2. Slide the drive carrier out of the
controller box.
3. Place the disk drive at an angle in the
drive carrier and connect the power
connector to the disk drive
4. Carefully connect the drive’s IDE
connector (P-ATA HDD use only) or
S-ATA(S-ATA HDD use only) connector
to the drive carrier connector.
格式化表格
註解 [V4]: replace the photo
註解 [V5]: replace the photo
註解 [V6]: replace the photo