RIDGID Lift Bracket Accessory 497 - Manual (Page 4)

2
INSTALLATION INSTRUCTIONS
1. Mount the brackets on the ENDS of the unit, as close to the
outside corners and as high up as possible. Place back-
ing plate on the inside surface, making sure your location
is not interfering with interior parts such as gas spring
guards, angles, etc. (See Fig. 1) Some units will come with
pre-punched holes for mounting the lifting brackets. In this
case, skip to step 4.
Figure 1 (Piano Box shown)
Figure 2 (Piano Box shown) Figure 3 (Piano Box shown)
Refer to ASME B30
for proper rigging
techniques
WARNING
AVERTISSEMENT
ADVERTENCIA
Figure 4
Figure 1 (Piano Box shown)
2. On certain applications, where the cover overlaps the body
of the box, verify that the placement of the bracket will not
interfere with closing of the cover before drilling. (See Fig. 2)
Figure 1 (Piano Box shown)
Figure 2 (Piano Box shown) Figure 3 (Piano Box shown)
Refer to ASME B30
for proper rigging
techniques
WARNING
AVERTISSEMENT
ADVERTENCIA
Figure 4
Figure 2 (Piano Box shown)
3. Mark holes and drill using .125 (1/8" / 3,18 mm) Drill bit for a pilot hole, then follow with a .406 (13/32 / 10,32 mm) dia. Drill bit.
4. Mount brackets with fasteners as shown in Fig. 3, and torque to 47 Ft. Lbs (6,5 kg/m). All four brackets must be used.
Figure 1 (Piano Box shown)
Figure 2 (Piano Box shown) Figure 3 (Piano Box shown)
Refer to ASME B30
for proper rigging
techniques
WARNING
AVERTISSEMENT
ADVERTENCIA
Figure 4
Figure 3 (Piano Box shown)
Figure 1 (Piano Box shown)
Figure 2 (Piano Box shown) Figure 3 (Piano Box shown)
Refer to ASME B30
for proper rigging
techniques
WARNING
AVERTISSEMENT
ADVERTENCIA
Figure 4
5. Mount decals on exterior of unit between the bracket as shown in Fig. 4.
Figure 4
Refer to ASME B30 for
proper rigging
techniques