En + drawings, How to put on and adjust the harness – Petzl SEQUOIA SWING User Manual
Page 5

5
C69SFA SEQUOIA SWING C695050D (080610)
6
How to put on and adjust the harness
6A. Putting on the
harness
Open the FAST buckles
on the leg straps.
Open up the harness
(untwisting the straps if
necessary) and holding
it by the belt, slip it on
over your legs and pull
it up to your waist.
6
How to put on and adjust the harness
Fast
Fast
Clic !
6B. Adjust the
thigh straps
Fasten the FAST
buckles. Check for
correct locking.
Adjust the sizing
a bit loose; if too
tight, it will be
uncomfortable.
Fast
Fasten the FAST
buckle on the belt.
Check for correct
locking. Tighten
the waistbelt
well. Stow the
excess webbing
neatly using the
strap retainers
(fl at against the
waistbelt).
6C. Adjust the DoubleBack buckles for the seat height
- Very tight adjustment with the DoubleBack buckles (9) touching the
thigh padding: most of your weight is on your backside, with slight lumbar
support.
You will have a tendency to keep yourself upright because the support
from the belt is too far back.
- Looser adjustment with several centimeters between the buckle and the
seat: your weight is distributed better between the backside and the lumbar
region, your body is tilted further back.
6D. Adjust the rear straps
These elastic straps allow adjustment of the
distance between the rear of the seat and the
rear of the belt.
- Adjustment is too loose: the seat hits your
legs when walking.
- Tight adjustment: the seat slides up under
the buttocks, staying out of the way when
you are moving about.
Test your adjustments in suspension on
each attachment point to be sure that your
harness is correctly sized and provides
adequate comfort.
DoubleBack