Gembird SIS-PMS-LAN - Manual (Page 61)

61
SIS-PMS-LAN PROGRAMMABLE SURGE
PROTECTOR WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
8. Troubleshooting
Problem Solution
The circuit breaker is activated
(tripped).
The load connected to the device is too
high, some of the devices connected to
the SIS-PMS-LAN should be disconnected
and the circuit breaker should be reset.
The switching command is not
carried out, the rocker switch
and indicators are not lit.
There is no power supply to the SIS-PMS-
LAN. Please, make sure the SIS-PMS-
LAN is connected to the power supply and
the rocker switch is switched on.
The status of SIS-PMS-LAN in
Power Manager does not
become Connected Try to ping the device (see section 5.1
above)
SIS-PMS-LAN is connected to
local network (ping test is ok)
but not responding.
Reset SIS-PMS-LAN by pressing the
Reset button on the side control panel
(see Figure #2 above) or switch it off and
then on again using the Main rocker
switch Z (see Figure #1 above).
Connection to SIS-PMS-LAN is
lost. It seems something is
wrong with its IP address.
Make sure SIS-PMS-LAN is connected to
LAN and switched on. Launch Find SIS-
PMS-LAN utility. You can also try to use
IP config (C) button to let the device renew
its IP address (see section 3.2 above)